Kismet Wireless

Kismet Forums

 

Posted by:dragorn
Subject:kismet on the SmartQ 7 ( Marvel SD8686)
Date:07:45:54 01/01/2010

> I was able to apt-get install kismet on my SmartQ 7 but not sure how to configure it. The SmartQ uses a "ARMv6-compatible processor rev 6 (v6l)" thus does not have a PCI bus. Also they have configured the unit for eth0, there is no wlan0:
>

Depends what the drivers are. Most custom drivers for a specific device don't include support for monitor mode.

If you can figure out how to get it into monitor mode, I'll add explicit support.

-m


Reply to this message