Kismet Wireless

Kismet Forums

 

Posted by:alchemyx
Subject:Logging to detected networks
Date:07:59:42 12/09/2009

> Kismet doesn't connect to networks (infact, you can't connect to a network while in monitor mode). The IP is derived from traffic on the network captured in monitor mode.
>
> Your options are probably either:
>
> 1) Do a run with kismet, then write a script to parse the netxml and do a slower run with an auto-connector.
>
> 2) Run two cards, and write a small bit of script to listen to the kismet network protocol and connect to each BSSID. With the newer Kismet releases you could even insert a tag to log the DHCP IP in the netxml file and process them later so the person running around doesn't even have to think much.
>
> There was a blog post with a basic network client in awk and bash, but basically all you need to do is connect, enable the BSSID and SSID sentences, parse those out, and use the ADDNETTAG protocol command to add EXTIP or some other field.

OK now I understand. I forgot that I can't connect to network in monitor mode. So second options seems fine. Thanks!


Reply to this message