Kismet Wireless

Kismet Forums


Posted by:dragorn
Subject:Cisco 350 error
Date:01:33:53 09/05/2009

> I am fairly new to linux. I cannot get kismet to work with my wireless card.
> here is what I get when I run Kismet:
> No specific sources given to be enabled, all will be enabled.
> Non-RFMon VAPs will be destroyed on multi-vap interfaces (ie, madwifi-ng)
> Enabling channel hopping.
> Enabling channel splitting.
> FATAL: Support for capture source type 'cisco_wifix' was not built. Check the output from 'configure' for more information about why it might not have been compiled in.
> Done.
> I am using a cisco 350. Thanks.

I haven't even looked at the cisco drivers in ~5 years. I don't even know how they react anymore, but that error sounds like you haven't compiled Kismet with pcap (or wext) support. Check the output of configure when building.


Reply to this message