Kismet Wireless

Kismet Forums

 

Posted by:pshootr
Subject:ipw2200 injection patch issue
Date:02:32:54 20/01/2008

Ok, awhile back I Installed the ipw2200 1.2.2 drivers, and appropriate firmware. I had kismet working. Tonight I reinstalled the 1.2.2 drivers after patching them with the ipw220 1.2.2-injection.patch. And now when start kismet I get this message below. Could this be because the source ID has changed.
-----------------------
~$ sudo kismet
Server options: none
Client options: none
Starting server...
Waiting for server to start before starting UI...
Suid priv-dropping disabled. This may not be secure.
No specific sources given to be enabled, all will be enabled.
Enabling channel hopping.
Enabling channel splitting.
Source 0 (wifi): Enabling monitor mode for ipw2200 source interface eth1 channel 6...
FATAL: Failed to set monitor mode: Invalid argument. This usually means your drivers either do not support monitor mode, or use a different mechanism for getting to it. Make sure you have a version of your drivers that support monitor mode, and consult the troubleshooting section of the README.
[1] + Done(1) ${BIN}/kismet_server --silent ${server}


Reply to this message