Kismet Wireless

Kismet Forums

 

Posted by:00
Subject:What are the correct settings for WRT54GL v1.1 ?????
Date:14:09:58 21/09/2007

> Depends on the firmware you loaded. Different firmware calls it different things. Different versions of the hw number interfaces differently. It's probably ethX, maybe prismX, or maybe ethX:prismX. Insufficient info. Figure out which one is your ethernet nic, put it in monitor mode manually with iwconfig, and see what happens if you don't know what your firmware calls the interfaces.
>
> -m

There is no iwconfig, as you can see I tried this below so the name is eth1??

===============================================================
Tomato v1.07.1039


BusyBox v1.2.2 (2007.05.06-15:48+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

# iwconfig
-sh: iwconfig: not found
# wlname=`nvram get wl_ifname`
# echo $wlname
eth1
#
================================================================


Reply to this message