Kismet Wireless

Kismet Forums

 

Posted by:acatala
Subject:Can't capture anything with Netgear WG511T
Date:16:05:17 21/07/2006

Hello,

I used to use Kismet with a Cisco Aironet PCM350 and worked fine. Recently I have purchased a Netgeat WG511T with Atheros chipset. I have downloaded latest madwifi-ng drivers (both stable and developer versions) and compiled.

I can use Netgear card with my PowerPC Powerbook with YelloDog with kernel 2.6.8, and I can associate with my AP and use it, but when I try to use Kismet 2006-04-R1 version I am able to run Kismet, but I can not capture any packet. When I run kismet both LEDs on Netgear card blink at 1 Hz (more or less), when I stop kismet then just one of them remain on. I have tried destroy ath0 managed mode before running kismet, and nothing else happens.

My configuration kismet.conf file is:

version=2005.06.R1
servername=Kismet
suiduser=(my login name)
source=madwifi_g,wifi0,Netgear
channelhop=true
channelvelocity=5
channelsplit=false
defaultchannels=IEEE80211g:1,6,11,2,7,3,8,4,9,5,10
tcpport=2501
allowedhosts=127.0.0.1
bindaddress=127.0.0.1
maxclients=5
gps=false
...

Thanks


Reply to this message