Kismet Wireless

Kismet Forums

 

Posted by:dragorn
Subject:Upgrade problem
Date:17:23:39 03/05/2006

> I've first install kismet on a OpenWRT RC4 and it was ok.
> After that, RC5 when out, So I re-install everything...
>
> Now I've got an error each time I'm trying to run my kismet_drone.conf
>
> FATAL: pcap reported netlink type 1 (EN10MB) for eth1. This probably means you're not in RFMON mode or your drivers are reporting a bad value. Make sure you have the correct drivers and that entering monitor mode succeeded.
> ./S60kismet_drone: 12: Syntax error: Unterminated quoted string
>
>
> I do not know if it's because of the driver, and I don't know how to change it too.
>
> Do someomne know what to do ?

You don't say how you have it configured. Maybe you switched to a firmware that uses the prismX device naming scheme, look at the readme for the two types of wrt54 source lines.

-m


Reply to this message