Kismet Wireless

Kismet Forums

 

Posted by:Brian999
Subject:Linksys WMP11
Date:14:49:15 10/04/2006

I'm confused about something here.

I have a Linksys WMP11 card that I THINK uses the Prism chipset. Everything I've been able to find indicates that it does use the Prism chipset and when I do an iwconfig it shows the nickname as "Prism I" (I doubt this is a reliable indicator of the chipset though) and the interface as eth0.

I do an "iwpriv eth0" and monitor is listed.

Since I couldn't put it into monitor mode using the Prism commands (or even start kismet for that matter) I tried uncommenting the orinoco line in kismet.conf and commented out the Prism line. I uncommented the orinoco line based on the appearance of eth0 when I did an iwconfig.

I am still unable to place the card in monitor mode though. Any ideas? Thank you!

I really have read all the documentation and I've googled as well to no avail. Now I feel as if I'm just spinning my wheels!

t seems


Reply to this message