Kismet Wireless

Kismet Forums

 

Posted by:AlxRogan
Subject:ipw2200 v1.1.1, fw3.0, no per packet signal strength in Kismet
Date:00:30:49 10/03/2006

> >
> > Understood about the signal levels outside of monitor mode.
> >
> > I had this working on a previous installation of Linux on this same equipment a few months ago with an earlier kismet-devel and earlier ipw2200/associated versions. I'll regress my settings a bit and see if I can identify a breakpoint.
> >
> > Thanks for the rapid response.
>
> Works fine here with 1.1.0 patched (the patch that became 1.1.1, so i don't expect any difference) on a 2915. I get the expected signal levels and no noise levels, which is as I'd expect it to be.
>
> Did you turn on radiotap support in your makefile?
>
> -m
Yes, taking cues from your Blog posting, I edited the Makefile and uncommented "CONFIG_IEEE80211_RADIOTAP=y". I couldn't find the IPW_FW_MINOR_VERSION, but since I was using the 3.0 firmware, I didn't think it mattered.

Thanks.


Reply to this message