Kismet Wireless

Kismet Forums

 

Posted by:dragorn
Subject:Fedora 2.6.12 and Cisco 350 card
Date:02:37:41 31/01/2006

> source=cisco,eth1,kismet. I have noticed that when I give the echo mode r command the config file for the card does change to rmon. If at this point I try and start kismet, then look at the card config file again it has been changed from rmon to any and I get a message stating the I may not have the card in rmon. Do I need to use wifi0? What commands do I need to use? I have tried:

Look at the docs. cisco is the wrong source.

-m


Reply to this message