| Posted by: | MrOrange |
|---|
| Subject: | double wireless card |
|---|
| Date: | 18:47:36 24/06/2009 |
|---|
I've a pc with 2 identical wireless card and I can't understand how should I configure kismet.conf in "source="
I've tried:
source=atheros,ath0,atheros
it doesn't work
lspci -vvv says:
02:04.0 Ethernet controller: Atheros Communications Inc. AR5413 802.11abg NIC (rev 01)
Subsystem: Atheros Communications Inc. Unknown device 1262
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 168 (2500ns min, 7000ns max), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 5
Region 0: Memory at e8000000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
02:05.0 Ethernet controller: Atheros Communications Inc. AR5413 802.11abg NIC (rev 01)
Subsystem: Atheros Communications Inc. Unknown device 1262
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 168 (2500ns min, 7000ns max), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 5
Region 0: Memory at e8010000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
no kernel driver or module are specified...
do you have any suggestion?
tnx
Davide
Reply to this message
