| Posted by: | abuas |
|---|
| Subject: | Orinoco USB and card rate in monitor mode |
|---|
| Date: | 09:44:21 02/09/2005 |
|---|
> I don't understand the question.
>
> Your card cannot transmit in monitor mode, ever. The data tx rate of the card in monitor mode is therefor totally irrelevant.
>
> If you don't see networks with the patch applied to 0.15 then you configured Kismet wrong.
>
> -m
Orinoco-usb is only supported properly in the newest CVS drivers, not in 0.15RC2. RC2 does not contain any module for support orinoco-usb. So you are probably using the latest code from CVS.
I must confirm, that the patch from March to CVS drivers is working WRONG and it corrupts frames, corrupt SSID's (visible in ethereal) at the page finally is causing any network invisible in Kismet. So you must run CVS drivers without any patches applied!
To admin: I advise you to correct the CVS patch - it only corrupts frames (you can see it in ethereal - without patch everything is OK).
Any information you can find at the page:
http://www.orinoco.host.sk
In this page you can find information how to setup properly orinoco-usb with kismet.
Cheers! :-)
Reply to this message
