| Posted by: | abuas |
|---|
| Subject: | Orinoco USB and card rate in monitor mode |
|---|
| Date: | 09:44:08 02/09/2005 |
|---|
> Hi
>
> I use 0.15rc2 CVS drivers version and when I run Kismet my card going to 2 Mb/s rate - I don't know why :(
> I can't change it when kismet is running or other program which use monitor mode.
> I don't use dragon patch because when apply it my card doesn't see any networks with kismet.
> All other things are good, but how I can apply 11 Mb/s to my card in monitor mode?
>
> Plase help...
Orinoco-usb is only supported properly in the newest CVS drivers, not in 0.15RC2. RC2 does not contain any module for support orinoco-usb. So you are probably using the latest code from CVS.
I must confirm, that the patch from March to CVS drivers is working WRONG and it corrupts frames, corrupt SSID's (visible in ethereal) at the page finally is causing any network invisible in Kismet. So you must run CVS drivers without any patches applied!
To admin: I advise you to correct the CVS patch - it only corrupts frames (you can see it in ethereal - without patch everything is OK).
Any information you can find at the page:
http://www.orinoco.host.sk
In this page you can find information how to setup properly orinoco-usb with kismet.
Cheers! :-)
Reply to this message
