Posted by:	ykcyc
Subject:	Kismet setup on Linksys WRT54G - success!
Date:	20:40:17 21/10/2003

> If I'm reading this corectly, this doesn't actually enable monitor mode.

Get shell on WRT54G and use /usr/sbin/wl to enable monitor mode.


Alex

Reply to this message

---

• Kismet setup on Linksys WRT54G - success! - ykcyc 01:11:26 18/10/2003
• no power or noise signal level reported - khanhex29 23:16:15 25/09/2004
• Kismet setup on Linksys WRT54G - success! - coder 17:51:44 29/02/2004
• Kismet setup on Linksys WRT54G - success! - wiz561 03:37:55 07/11/2003
• Precompiled Binary Available - Rusty 06:10:52 23/11/2003
• Kismet setup on Linksys WRT54G - success! - moerdock 11:57:42 18/10/2003
• Kismet setup on Linksys WRT54G - success! - Steve 02:59:53 21/10/2003
• Kismet setup on Linksys WRT54G - success! - ykcyc 20:40:17 21/10/2003
• Kismet setup on Linksys WRT54G - success! - jb17 06:55:26 23/10/2003
• Kismet setup on Linksys WRT54G - success! - ykcyc 21:07:58 24/10/2003
• Kismet setup on Linksys WRT54G - success! - Traveller 19:14:23 30/10/2003
• Kismet setup on Linksys WRT54G - success! - dragorn 01:13:57 25/10/2003
• Kismet setup on Linksys WRT54G - success! - ykcyc 14:02:58 25/10/2003
• Kismet setup on Linksys WRT54G - success! - Rusty 23:26:35 21/11/2003
• Kismet setup on Linksys WRT54G - success! - troycicle 07:44:05 23/06/2004