| Posted by: | Xitro |
|---|
| Subject: | problem with the source line |
|---|
| Date: | 17:29:36 06/09/2006 |
|---|
> helooo / sorry for my bad englisch/
>
> my wlan card is wpc54g
> the card is installed with the ndiswrapper-0.11
> when I start kismet there come the message>
> FATAL: Source 0 (kismet): Unknown card type 'Broadcom'
>
> The real name of my wireless card is "linksys Wireless-G" model WPC54G ver 1.2
> but when I write the name in the source line I always see the message unknown card type...
> i tried with different names of the card but it doesn't worked...
>
> modprobe ndiswrapper
> iwconfig wlan0
>
> wlan0 IEEE 802.11g ESSID:off/any
> Mode:Managed Frequency:2.437GHz Access Point: 00:00:00:00:00:00
> Bit Rate:54Mb/s Tx-Power:16 dBm
> RTS thr:2347 B Fragment thr:2349 B
> Encryption key:off
> Power Management:off
> Link Quality:100/100 Signal level:-10 dBm Noise level:-256 dBm
> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
> Tx excessive retries:0 Invalid misc:458 Missed beacon:0
>
> thanks for help...
> i have the same problem with my ipw2100 card...
Hey, I've got the same problem with my ipw2200 card.
When I know how to solve it, I'll tell u!
Bye
Reply to this message
