| Posted by: | dadaf |
|---|
| Subject: | problem with the source line |
|---|
| Date: | 18:31:27 14/11/2004 |
|---|
helooo / sorry for my bad englisch/
my wlan card is wpc54g
the card is installed with the ndiswrapper-0.11
when I start kismet there come the message>
FATAL: Source 0 (kismet): Unknown card type 'Broadcom'
The real name of my wireless card is "linksys Wireless-G" model WPC54G ver 1.2
but when I write the name in the source line I always see the message unknown card type...
i tried with different names of the card but it doesn't worked...
modprobe ndiswrapper
iwconfig wlan0
wlan0 IEEE 802.11g ESSID:off/any
Mode:Managed Frequency:2.437GHz Access Point: 00:00:00:00:00:00
Bit Rate:54Mb/s Tx-Power:16 dBm
RTS thr:2347 B Fragment thr:2349 B
Encryption key:off
Power Management:off
Link Quality:100/100 Signal level:-10 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:458 Missed beacon:0
thanks for help...
i have the same problem with my ipw2100 card...
Reply to this message
