| Posted by: | mathew |
|---|
| Subject: | Which Module should i give in the config as ´source´ |
|---|
| Date: | 15:40:02 31/10/2008 |
|---|
Hello,
as i am new to kismet i wonder, which module i should take from the §12 section described here to give kismet in its config as source. i use a atheros card from tp-link wn 651g.
lspci | grep -i net gives me:
07:05.0 Ethernet controller: Atheros Communications Inc. AR5212/AR5213 Multiprotocol MAC/baseband processor (rev 01)
dmesg gives me:
[ 46.827009] wifi0: Atheros 5212: mem=0xfd7e0000, irq=20
what is then the rigt choice to put into source? When i go into monitor mode the interface is ath0.
cheers
mathew
Reply to this message
